beautypg.com

Unpacking, Inserting batteries into the remote, Notes – Sony SA-VA29 User Manual

Page 4: Installing the speaker bases, Getting started

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Getting Started

Unpacking

Check thiit \ ou recei\ ed the following items with vonr

speaker system:

• External center speaker SS-CN15VA (1)

• Rear speaker SS-SRl 71 (2)

• Front L/R speaker connecting cord, 3.5 m (1)

• Center speaker connecting cord, 2.5 m (1)

• Rear speaker connecting cord, 10 m (2)

• Audio connecting cord, 1.5 n\ (1)

• Remote commander (remote) RM-J59 (1)

• Sony size-AA (R6) batteries (2)

• Speaker bases (2)

• Wood screws (8)

• Foot pads (4)

Attaching the supplied foot pads to the
external center speaker

To place the external center speaker on vour TV set,

attach the supplied foot pads to the hottom of the

speaker, one in each of the tour corners. Make sure

that the speaker stands flat on top of the TV.

Foot pads

Do not place the speaker on top of a TV set which is smaller

than the speaker.

Inserting batteries into the remote

Insert two size-AA (R6) batteries with the terminals

matched to the + and - on the battery compartment.

When using the remote, point it at the remote sensor II

on the front speaker (left).

When to replace batteries

Under norma! use, the batteries should last for about 6

months. When the remote no longer operates the

speakers, replace both batteries with new ones.

Notes

• Do not leave the remote in an extremely hot or humid

place.

• Do not use a new battery with an old one.

• Do not expose the remote sensor to direct sunlight or

lighting apparatuses. Doing so may cause a malfunction.

• If you do not use the remote for an extended period of

time, remove the batteries to avoid possible damage from

battery leakage and corrosion.

Installing the speaker bases

Be sure to install the supplied speaker bases before you

use the speakers.

1

Use a screw driver to fasten the bases to the

bottom of the speakers with the supplied wood

2

Make sure the bases are securely attached and

stand the speaker upright.