Sony MDS-JE700 - Manual (Page 14)

Il
Recording on MDs
Recording Over Existing Tracks Adjusting the Recording Level
Follow the procedure below to record over existing
material just as you would on an analog cassette tape.
IKK AMS OOll
© O
oo
ooaoo
O O O O O
O O O O O
O O O O O
O O O O O
O O O O O
OOOOO
oooo
tZEOHS
|isua|Q3
ssaa
1
Do Steps 1 to 5 in "Recording on an MD" on page
9.
2
Turn AMS (or press or ►►!) until the
number of the track to be recorded over appears.
3
To record from the start of the track, continue
from Step b in "Recording on an MD" on page 10.
While "TRACK" flashes in the display
The deck is recording over an existing track, and stops
flashing when it reaches the end of the recorded
portion.
When recording with INPUT at ANALOG and the
signal input through LINE (ANALOG) IN jacks, use
REG LEVEL to adjust the recording level before
starting recording.
You cannot adjust the recording level during digital
recording.
REC LEVEI
1
Do Steps 1 to 6 in "Recording on an MD" on
pages 9 and 10.
2
Play the portion of the program source with the
strongest signal level.
3
While monitoring the sound, turn REC LEVEL t(
adjust the recording level so that the peak level
meters reach their highest point without turning
on the OVER indication. Occasional lighting of
"OVER" is acceptable.
'^'To record from the middle of the track
1 After Step 2 above, press O to start playback.
2 Press II where you want to start recording.
3 Continue from Step 6 in "Recording on an MD" on
page 10.
Note
You cannot record from the middle of an existing track when
the "PROGRAM" or "SHUFFLE" is on.
Without turning on the OVER indication
4
Stop playing the program source.
5
To start recording, do the procedure starting fro
Step 8 in "Recording on an MD" on page 10.
14