Sony DHC-MD500 - Manual (Page 44)

Specifications
AUDIO POWER SPECIFICATIONS:
(DHC-MD500 U.S.A. models only)
MOWER OUTPUT AND TOTAL
I lAR.MONIC DISTORTION:
vN'ith 6 ohm k^ads both channels driven, from
7(}-20,000 H/; rates 60 watts per channel
minimum RMS power, with no more than
total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
DHC-MD500:
C ontinuous RMS power output (reference)
60 + 60 watts
(6 ohms at 1 kHz,
i07:, THD)
Intal harmonic distortion less than 0.07%
(6 ohms at 1 kHz, 45 W)
DHC-RX707:
f )l\ pou’er output (rated) 60 + 60 watts
(6 ohms at 1 kHz, DIN)
( nntmuous RMS power output (reference)
80 + 80 watts
(6 ohms at 1 kHz,
]0% THD)
M u s k p o w e r o u t p u t ( r e f e r e n c e )
135 + 135 watts
(6 ohms at 1 kHz,
10% THD)
Inputs
.MD/VIDEO IN:
(phono jacks)
.MIX MIC: (phone jack)
voltage 450 mV/250 mV,
impedance 47 kilohms
sensitivity 1 mV,
impedance 10 kilohms
Outputs
MD/VIDRO OUT: voltage 250 mV
(phono jacks) impedance 1 kilohms
PHONES: accepts headphones of 8
(stereo phone jack) ohms or more
SPRAKER: accepts impedance of 6 to
16 ohms
SL'PI-.P W(X)FER:
(DIK -MDiOO only):
Voltage 1 V, impedance 1
kilohm
CD player section
System
Laser output
Frequency response
VVa\’elength
Signal-to-noise ratio
Dynamic range
Compact disc and digital
audio system
Semiconductor laser
(X=780nm)
Emission duration:
continuous
Max. 44.6
‘This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
2 Hz-20 kFIz(±0.5dB)
780 - 790 nm
More than 90 dB
More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength
600 nm
Output Level -18 dBm
Tape player section
Recording system
Frequency response
(DOLBY NR OFF)
Wow and flutter
4-track 2-channel stereo
40- 13,000 Hz (±3 dB),
using Sony TYPE I
cassette
40- 14,000 Hz (±3 dB),
using Sony TYPE II
cassette
±0.15% W.Peak (lEC)
0.1% W.RMS (NAB)
±0.2% W.Peak (DIN)