Sony CDP-CX57 - Manual (Page 19)

Playing CDs
4 Push the JOG dial.
The track being programmed
The disc being playing order
programmed
5 To program other discs / tracks, do the following:
To program Repeat Steps
All tracks of another disc(s) 2 and 4
Other tracks on the same disc 3 and 4
Other tracks on other discs 2 to 4
6
Push the JOG dial or press O to start Program
Play.
To cancel Program Play
Press PLAY MODE.
y The programs remain even after Program Play ends
when you push the JOG dial or press O, you can play
the same program again.
When you press PLAY MODE to select Program Play
during Continuous or Shuffle Play
The program will be played after the current track.
'Q'
The program remains until you erase them
Even if you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
Notes
• If you press the PLUS ONE button during Program Play,
Program Play will be canceled (see page 19).
• If you press one of the GROUP 1-5 buttons to start Group
Play, Program Play will be canceled (see page 28).
Creating a program using the remote
DISC-
>10
CHECK
CDCD&
CDOC3
OCD
ooo
ooo
ooo
^|o[®
ocpcs-
O O C D
□DCZD
PROGRAM
Number
buttons
ENTER
CLEAR
1 Press PROGRAM.
2 Press DISC.
PROGRAM
C01
2 0
D I S C - [ -L'i
__________ iLu-X___________
3 Press the number button of the disc.
PROGRAM
GDI
2 0
D I S C - [ г p d
4 To program a whole disc, press ENTER and go to
Step 6.
Press >10.
5 Press the number button of the track.
The number you pressed is entered into the
flashing digit. When the disc has more than 10
tracks, press 0 first then press the corresponding
number to enter a track number from 1 to 9.
The disc being programmed
18
The track being programmed Playing order