Two Brothers Racing Ducati 696 User Manual
V.a.l.e, Juice box™ - fuel controller
Two Brothers Racing
Juice Box™ - Fuel Controller
2009 Ducati 696 Installation & Operation Manual
Part # 008-249
Parts Incuded
Installation Instructions
Qty.
Description
Part Number
1
Juice Box™ Fuel Control Kit
008-249
(#9120220)
3
Zip Ties
1
Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Remove bottom tank bolt. (fig.5)
Pull the fuel tank back and prop it up. (fig.6)
Locate left injector and unplug OEM connector and plug
in the JUICE BOX™ female end into the injector and male
end into the OEM harness. (fig.7)
Locate right side injector and pass wire through engine
compartment to plug into the left side injector and the
male end into the OEM harness. (fig.8)
Run the JUICE BOX™ to rear of bike along the frame rail
to secure under the seat base using the supplied velcro
tab and zip ties for the wires. (fig.9)
7.
8.
9.
10.
11.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions
first before starting installation. Make sure the vehicle and exhaust system are
completely cool before starting the installation. Also, make sure the vehicle is
secure during installation. Be sure to save all stock components for possible use
later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is
not applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway
or off-road vehicles. The Juice Box™ is not applicable, nor inteded for use on
aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove the seat assembly.
Remove the fuel tank top cover screws. (fig.1)
Remove fuel tank top cover. (fig.2)
Remove side fuel tank covers. (fig.3)
Remove fuel tank by removing lower bolt that secures
tank from sliding rear-ward. (fig.4)
1.
2.
3.
4.
5.
6.
Continued on page 2
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Fig 6
Fig 7
Fig 8
Fig 9