Two Brothers Racing Yamaha Rhino 700 User Manual
V.a.l.e, Juice box™ - fuel controller, Two brothers racing

Two Brothers Racing
Juice Box™ - Fuel Controller
2008 Yamaha Rhino 700 Installation & Operation Manual
Part # 008-217
Parts Incuded
Installation Instructions
Qty.
Description
Part Number
1
Juice Box™ Fuel Control Kit
008-217
3
Zip Ties
1
Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Unplug the OEM connectors and plug in the JUICE BOX™
connector in place of the current wire as shown (Fig. 4).
Connect the ground wire to ground at driver’s seat (coil
ground) (Fig. 5).
The Two Brothers Racing Crew recommends attaching
the JUICE BOX™ to the top of the shifter case using
the velcro square provided. Route the wire plugs up
through the e-brake hande hole. We also used the zip ties
provided to keep the wires together once connected (See
Fig. 6a,b).
NOTE: Re-check your wire routing and JUICE BOX™
location and make certain that in no way the wires can
come into contact with any moving parts or high heat
source and that the JUICE BOX™ is mounted in a way as
to not cause a handling problem with the machine.
5.
6.
7.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified ATV technician. If
you have any doubts as to your ability to install this performance part, please consult
with your local ATV dealer. Read all instructions first before starting installation. Make
sure the vehicle and exhaust system are completely cool before starting the installation.
Also, make sure the vehicle is secure during installation. Be sure to save all stock
components for possible use later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove both the driver’s seat and the passenger seat
by pulling up the latch at the front of each seat base (See
Fig.1).
Remove the plastic engine cover (Fig. 2).
Locate the fuel injector plug at the top of the throttle body
(Fig. 3a,b).
1.
2.
3.
4.
Fig 1
Continued on page 2
Fig 4
Fig 2
Fig 3a
Fig 3b
Fig 5
Fig 6a
Fig 6b