Two Brothers Racing Yamaha FZ-1 - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2006-08 Yamaha FZ-1 Installation & Operation Manual
Part # 008-150
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-150
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Remove the injector connectors one at a time. Connect the
JUICE BOX™ harness to the injector, and the stock injector
connector to the JUICE BOX™ harness. (Fig 5)
Disconnect the Oxygen sensor connector and install the
JUICE BOX™harness. (Fig 6)
Tuck the wiring in to prevent pinching under the tank. (Fig 7)
Connect the JUICE BOX™ ground to the battery negative.
(Fig 8)
Start the bike. The green LED should now be scrolling for
about 3-5 seconds and then go to 1-2 steady green LED’s
or a single slow flashing green LED. If the number 1 green
and number 8 red LED continue flashing after startup, an
injector wiring error is indicated. Re-check the wires from
the JUICE BOX™ and make sure they are connected to the
proper wire of your bike’s stock harness. MAKE SURE you
have the correct connectors selected in the stock harness.
DO NOT PROCEED UNLESS ABOVE CONDITIONS ARE
MET.
6.
7.
8.
9.
10.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting the
installation. Also, make sure the vehicle is secure and will
not roll around.
Remove the 4 fasteners each side and remove the L & R
dash inserts. (Fig 1)
Remove the 5 fasteners and remove the tank apron. (Fig 2)
Remove the 2 front fuel tank fasteners. (Fig 3)
Locate the 4 injectors and the Oxygen sensor connector. (Fig 4)
1.
2.
3.
4.
5.
Continued on page 2
Fig 1
Fig 5
Fig 2
Fig 3
Fig 4
Fig 6
Fig 7
Fig 8