Two Brothers Racing Suzuki B-King - CA Emissions Legal - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2008 Suzuki B-King Installation & Operation Manual
Part # 008-195C
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-195C
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Twist and remove ignition cover from ignition cover and
remove 5 Allen bolts (Fig 6). Lift housing to gain access to
the two connectors and disconnect.
Remove (4) Allen screws remove covers and (2) 8mm
socket head tank bolts (Fig 7).
Remove tank support rod located next to battery (Fig 8).
Lift tank and support with rod as shown in (Fig 9).
Locate lower injectors. Note: This bike is equipped with
two sets of injectors lower and uppers we are only
concerned with the lower injectors (Fig 10). Disconnect
injector connector and plug the black JUICE BOX™
connector onto the injector and plug the black connector
from the JUICE BOX™ into the stock black connector.
Repeat on remaining 3 cylinders.
6.
7.
8.
9.
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove seat.
Remove side panel, both sides (Fig 1).
Remove screw from tank panel, both sides (Fig 2).
Remove Allen screw from front turn signal housing (Fig 3)
and two plastic fasteners (Fig 4-5), and remove housing.
Repeat on opposite side.
1.
2.
3.
4.
5.
Continued on page 2
Fig 1
Fig 7
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.
This Juice Box is legal for use on Emissions Controlled street and highway vehicles.
The Juice Box™ is not applicable, nor inteded for use on aircraft.
Tools Needed For Install
- No. 3 Phillip screwdriver
- 3-5 mm Allen wrench
- 8-10 mm wrench/socket
- Owner’s manual
Fig 2
Fig 6
Fig 8 Fig 9
Fig 10
Fig 4 Fig 5
Fig 3