Two Brothers Racing Can-Am Spyder Renegade 800 User Manual
Page 5
ITBR001-256
www.twobros.com
2006-09 Outlander 800/2007-10 Renegade 800 - 5
Figure G
Figure H
Figure I
10. Locate the Throttle Position Sensor (TPS) connector.
The TPS connector is located on the rear of the throttle body as shown in
Figure G.
11. Unplug the TPS connector.
12. Attach the supplied posi-tap to the white/brown wire
of the TPS harness.
13. Attach the grey wire from the Juice Box Pro to the
posi-tap.
Note: It is recommended to use dielectric grease on
these connections.
14. Plug the wiring harness back onto the TPS.
15. Route the ground wire from the Juice Box Pro to the left hand side of the throttle
body and follow the stock ground wires down to the right hand side of the engine
as shown in Figure I.
16. Attach the ground wire from the Juice Box Pro to the common ground lug of the
engine as shown in Figure I.
17. Reinstall the side covers.
18. Reinstall the seat.
grey wire from
Juice Box Pro
unplug
ground wire
bolt