Setting up the faxpress premier analog, Premier analog requirements, Connecting the premier analog to your network – Castelle FAXPRESS PREMIER 61-1260-001A User Manual
Page 14: Connecting the premier analog to your network on
Getting Started
12
Setting Up the FaxPress Premier Analog
IMPORTANT!
Before beginning the steps described in this section,
make sure you’ve carefully reviewed the
Premier Analog Requirements
The FaxPress Premier Analog requires:
• that each fax channel be connected to a dedicated phone line. The
Premier Analog may have 8, 12, or 16 fax channels.
Note:
When connecting the FaxPress Premier Server through a PBX,
it is required that a trained PBX technician be on site.
• that you know the input string of DTMF digits from the PBX to the
FaxPress Premier Analog fax lines, if the Premier is connected
behind a PBX and automatic inbound routing will be used. A mask
will need to be configured for FaxPress Premier Analog to
recognize the input string. See
Automatic Routing
in the
Administrator’s Guide for detailed information on integrating the
Premier with your PBX system.
• a third party device like the Exacom DID Interface Module if
you’re using a DID trunk without a PBX system. See
Automatic
Routing
in the Administrator’s Guide for detailed DID
information.
Connecting the Premier Analog to your
Network
To connect the Premier server to your network, follow these steps:
1. Connect the network cable to the Premier server’s Ethernet port.
2. Connect the fax lines to the FaxPress Premier’s fax modem ports.
(See the next section,