Tri-Tronics Sport® Series Remote Trainers - Manual (Page 5)

QUICK GUIDE
Before You Start…
1.
Install the collar strap(s) (page 7).
2. Install the transmitter antenna (page 9).
3. Charge collar battery for 14 hours (page 16).
The transmitter is shipped with a 9-volt battery already
installed, and does not need to be charged.
4. Select the correct length contact points for your dog’s coat.
(page 8).
Using the Remote Trainer
1.
Turn the collar on: Press the gray button on the collar
next to the contact points. The collar light will start
blinking and you will hear two tones, confirming that
the collar is on. (A rapid blink means that collar batteries
are low.) To turn the collar off, repeat the turn-on
process. One tone confirms that the collar is off (page 9).
2. Fit the collar on the dog: Fasten the collar strap
midway between dog's ears and shoulders, and buckle
s n u g l y. The collar light should face toward the dog’s nose.
Do not leave a collar on a dog continuously (page 10).
3. Select an intensity level for training: Level 1/2 is the
lowest; level 5 is the highest. Release the transmitter
button when changing levels during training. Intensity
selection tips are in your training manual and video (page 11).
4. Transmitter buttons (page 2) :
Select the button that will produce the desired type and
level of stimulation (Model Guide on page 4).
Note that when the intensity dial for the Sport
® 50 S ,
Sport ® 60 S and Sport ® 65 BPR S is set to “N”, all
transmitter buttons are disabled and stimulation
cannot occur (page 13).
Also note that when the intensity dial for the
Sport
® 80C, Sport ® 80M, Multi•Sport ® 2 S and
Multi•Sport ® 3 S is set to “T”, any transmitter button will
activate the no-stimulation signal tone (page 13).
Quick Guide Page 1