Tri-Tronics Sport® Series Remote Trainers - Manual (Page 13)

INSTALLING THE TRANSMITTER ANTENNA
Screw the transmitter antenna into
the top of the transmitter. Hold the
antenna near the base and tighten
firmly by hand. Check the antenna
regularly for tightness.
MIGHTY MICRO ANTENNA
( S p o rt ® 80C and Sport ® 8 0 M )
The Sport ® 80C and 80M come with two
antennas, the regular 3-inch one, and
the convenient Mighty Micro antenna
that is 1-1/2 inches long. The Mighty
M i c ro antenna will give you appro x i m a t e l y
60% of the range of the regular antenna (i.e., one-third of a
mile). Use the antenna that is right for the range you need.
The Mighty Micro antenna is available as an accessory for use
with other Tr i - Tronics Remote Trainer models. Contact your
Tr i - Tronics dealer or our Customer Service Depart m e n t .
TURNING THE REMOTE TRAINER ON AND OFF
The Remote Trainer consists of a hand-held transmitter and
a radio receiver on the dog’s collar. The collar must be turned
on before it can receive signals from the transmitter. To save
battery life, turn the collar off between training sessions.
To turn the Remote Trainer collar on, press the gray button
on the collar. The collar light will start blinking or “double
flash” (page 6) and you will hear two tones, confirming that
the collar is on.
To turn the collar off, press the gray button. You will hear
one tone confirming that the collar is off.
You can also turn a collar off by placing it on its charger.
Installing the Transmitter Antenna • Mighty Micro Antenna • On and Off Page 9
Hold the antenna
near its base and
tighten by hand.
When the collar
light blinks red,
the collar is on
On/off Switch