Tri-Tronics Sport® Series Remote Trainers - Manual (Page 16)

USING THE STIMULATION BUTTONS
All Sport ® Series models other than the Multi•Sport ® 2 S and
Multi•Sport ® 3 S offer two types of stimulation, “continuous”
and “momentary.” The black button(s) applies momentary
stimulation. The red button(s) applies continuous stimulation.
Multi•Sport ® 2 S and Multi•Sport ® 3 S models offer continuous
stimulation only. Pressing the colored transmitter button –
green, orange, or yellow – will cause the collar with the
matching colored strap to apply continuous stimulation.
(Be sure you have installed the correct color strap on each
receiver, as described on page 7.)
Note that for a button to apply stimulation the intensity dial
must be on a number (not on the “N” or “T” setting). Some
Sport
® Series models have the “N” setting on the intensity dial
and some have the “T” setting. Please see the “Model Guide”
(pages 4-5) for the features of your model.
Continuous Stimulation
The trainer controls timing of continuous stimulation.
Continuous stimulation stays on while the transmitter button
is pressed, up to a “time out” of about nine seconds. (If the
collar times out, release the button briefly to restore collar
function. Time-out is a very rare occurrence, and most
corrections will be far shorter than the time-out period.)
Momentary Stimulation
The duration of momentary stimulation is pre-set.
Momentary stimulation stays on only very briefly, no matter
how long the button is pressed. To produce a second momen-
tary correction, press the button again. To produce a series of
momentary corrections, press the button for each correction.
Multi-Dog Models
The Multi•Sport
® 2 S allows you to control two dogs at a time.
The Multi•Sport ® 3 S allows you to control three dogs at a
time. Each color-coded transmitter button – green, orange, or
yellow – corrects the dog who is wearing that color strap.
Page 12 Sport ® Series