Tri-Tronics Sport® Series Remote Trainers - Manual (Page 11)

INSTALLING THE COLLAR STRAP
Your Remote Trainer is shipped
with the receiver separate from
the collar strap. Install the strap
as shown. On multi-dog units
(the Multi•Sport
® 2 S and
Multi•Sport ® 3 S ), be sure to
install the correct color strap
on each receiver. Use the strap
that matches the colored dot
on the receiver.
You can easily adjust the strap for different sized necks by
sliding the receiver along the strap. If the strap is too long for
your dog, you can cut off excess length. Leave enough length
to go through any D-ring or keeper that is present (see
"Fitting the Collar on the Dog" page 10). Note that you will
need extra strap length to go around the Beeper, so do not cut
the collar strap of the Sport
® 65 BPR S until after you have
installed both the Beeper and the receiver on the strap.
You may also use any collar strap that fits the receiver.
Installing the Collar Strap Page 7
Slide the correct color strap through one side of the receiver, then
through the other side. Snug the strap firmly against the surface of
the receiver. Position the buckle where it is convenient for the size
of your dog's neck.