Tri-Tronics Sport Upland G3 - Manual (Page 18)

Page 30
DIP Switch Settings. Hold the Beeper so that the
switches are on the top edge of the compartment, as
shown in the diagram.
You do not need to turn the Beeper off to change the
settings or to make the new settings take effect.
To select your settings, set the switches in the
positions shown in the diagram below. The switch
is indicated by the dark in the diagram section. All switches except the volume
switch make a confirming
“chirp” when their positions
are changed.
Replace the battery
compartment cover
when done.
9-volt battery
DIP Switches
When setting switches,
hold the Beeper as shown
1 2 3 4 5
Low High
Range/Point Point-Only
Single Beep Double Beep Triple Beep Tracking Tone
Single Tone Hawk Scream
Volume Switch:
Modes:
Run Tones:
Point Tones:
Page 29
Run Tones. Single Beep, Double Beep, Triple Beep, or Tracking Tone. You may
select one of four tones as your run tone. When the Beeper is set on range/point
mode, you will hear the run tone every 5 seconds while the dog is hunting. Your
hearing and your personal preference will determine which run tone you prefer.
You can distinguish among several dogs hunting at the same time by setting each
dog’s Beeper on a different run tone. The tracking tone reflects some of the actual
hunting motion of your bird dog, much like the jingle of the traditional bell. It
enables you to keep track of how your dog is hunting better than the beeping of
the other run tones. Note that using the tracking tone will shorten battery life and
you will need to change the 9-volt battery in the Beeper more frequently.
Point Tones. Single Beep or Hawk Scream. You may select one of the these two
tones as your point tone. You will hear the point tone once every 1 second while
the dog is on point. Your hearing and your hunting preference will determine
which point tone you prefer.
Changing Beeper Settings
Battery Compartment. Hold the Beeper upside down and unscrew the four
Phillips head screws on the bottom of the Beeper. Slide the battery compartment
cover along the collar strap to expose the battery compartment and the Beeper
DIP switches.
Volume Modes Run Tones Point Tones
1 2 3 4 5
Dark indicates switch position