Sound Anchors DL5 system - Manual (Page 16)

Page 16 of 28
Initialisation of the DESKLINE DL5/DL6 parallel systems
The DESKLINE system is intialised by pressing the down button once or twice and holding it down until DL5/
DL6 runs into end stop, it will then automatically run approx. 3 mm out again and hereafter slowly running in
again. Only release the down button when the movement has completely stopped.
If the key is released before the sequence is completed then the initialisation is interupted and must
be started again from the beginning.
It is sometimes necessary to press the down button twice to start the initialisation this is because the system
can be in different modes when the initialisation starts.
Approx. 5 mm
The CBD5 and CBD6 can control DL5 and DL6 in 2 parallel while the CBD4 can control DL5 and DL6 in 2, 3,
and 4 parallel so that the desk is always kept horizontal.