Sound Anchors DL5 system - Manual (Page 15)

Page 15 of 28
Figure 4
DL5/DL6 cable
DL5/DL6
Electrical connection of the DL5/DL6 system
The DESKLINE ® DL5/DL6 system is to be connected as shown on fi gure 4. Each DL5/DL6 is to be connected to
the sockets on the control box by means of the motor cables, which have an 6-pin plug in each end.
Please note that the control box must only be connected to the voltage stated on the label.
Finally, the mains cable is to be mounted and power switched on.
DP/WDPL
Mains cable
DL5/DL6
Hook for cable relief
Figure 5
CBD4/CBD5/CBD6 with earth
The CBD4/CBD5/CBD6 earth cable to be mounted on the desk construction (typically the top frame)in a way
that ensures good electrical contact. The function of the earth cable is to earth the desk and ground static
electricity. The earth connection does not protect other electrical products.
CBD4/CBD5 with mains cut-off (non ZERO models)
If the power cable is damaged it has to be replaced by an authorized LINAK service centre to avoid
any danger.