Strand class i eye splice – Samson 16-STRAND Class I Eye Splice User Manual
Page 3
PAGE 3 OF 3
SamsonRope.com
| Tel
+1.360.384.4669
16-Strand Class I Eye Splice
S A M S O N S P L I C I N G I N S T R U C T I O N S
7
7
A
Pull buried core tails and cover yarns out of rope at their respective
exit points until about 13 inches are exposed. This is the distance
that the tail and core yarns overlap in the splice.
7
b
Cut both cover tail and core yarns
where they were marked in Step 6C.
step
f i n a l ta p e r
13"
Cut here
13"
mark c
mark d
mark B
mark a
core yarns
tail
Cut here
8
step
8
A
Secure knot firmly in place and pull sharply on eye to make sure all slack is re-
moved from splice area and that the cover and core tails are seated properly.
8
b
Optional: Apply whipping to base of eye for
a distance of about 1 inch or 2 rope diameters.
Optional
whipping
f i n i s h i n g t h e s p l i c e
7
D
Bury the exposed ends by alternately smoothing the
rope from the eye down and from the knot up.
7
c
Measure from the cut ends back 6-1/2 inches towards the point where they exit from the rope (both the cover and core
tails.) Taper the tails by cutting out 1 S-twist and 1 Z-twist strand approximately every 1-1/2 inches. This taper provides
a smooth transition from the buried tail of the splice to the core yarns extending down the remainder of the rope.
6-1/2"
6-1/2"
mark c
mark d
mark B
mark a
Finished splice
DOCUMENT 16Strand_C1_Eye Splice_AUG2012.pdf
© 2012 Samson Rope Technologies, Inc. All rights reserved.
S/WD #108294 7/2012