Owner s manual, Obd2 code scanner, 3 oil reset – Roadi RDT55 User Manual
Page 26

OWNER S MANUAL
,
OBD2 CODE SCANNER
24
3.3 Oil Reset
1). Turn the ignition off.
2). Locate the vehicle's 16-pin Data Link Connector (DLC).
3). Plug into the scan tool cable connector to the vehicle's DLC.
4). Turn the ignition on. But do not start the engine.
5). Press the
Y button. The main menu will be observed on the display.
6). Use the
UP/DOWN scroll buttons to select Oil Reset from the menu,
Press the
Y button, accept the option and to move to the next screen.
7). Do the following to select menu options:
a). Use the
UP/DOWN scroll buttons to move the cursor ( ) and select an
option.
b). Press the
Y button to accept the option and to move to the next screen
c). Repeat a) and b) to select the necessary options.
8). Follow any on-screen instructions. Optionally, use the
N button to return to
previous screens.
Main Menu
=============================
Oil Service
===========================
1) VW/AUDI
2) OBDII/EOBD
3) Oil Reset
4) EPB Reset
5) System Setup
6) Tool Information
1) ALL
2) AUDI (Up to 2000)
3) VW (Up to 2000)
4) Seat (Up to 2000)
5) Skoda (Up to 2000)
9). If the Service Reset Failed message appears then there mig ht be
problems for the scan tool to communicate with the vehicle being tested.
Refer to the vehicle service manual for more information.
10). When done, turn off the ignition and disconnect the scan tool.