Roadi RDT55 - Manual (Page 16)

OWNER S MANUAL
,
OBD2 CODE SCANNER
14
3). If you do not want to proceed with erasing the codes, press the
N button
to exit. A message of
"command cancelled" will show up.
4). If you do wish to proceed to erase the codes, then press the
Y Button.
5). If the codes are cleared successfully, an "
ERASE DONE!" confirmation
message will show on the display. Press any button to return to the previous
menu.
6). If the codes are not cleared then an
"ERASE FAILURE!" message will
appear. Press the
N button to return to previous menu.
Viewing ECU Information
1). To view ECU Information. Use the
UP/DOWN scroll buttons to select
ECU Information from the Select Function menu and press the Y button.
If the scan tool is not connected or no communication is established with
the vehicle yet, then refer to Reading Codes from 1 to 7 at Paragraph 3.l.
If there is no ECU Information available, a warning message shows on the
display.
2). Press the
N button to return to previous menu.
Select Function
ECU Information
======================================
===================================
1) Read Codes
2) Erase Codes
3) ECU Information
4) Readiness Test
AG No.:06A906032TF
Component:
Bosch 1.815VT
0020
Coding: 0008570
Imp: 0000 WSC:000078
Readiness Test
Important: The Readiness Test function is used to check the
Operations of the Emission System on OBD2 / EOBD compliant