Pro-Tools 105B - Manual (Page 10)

105-SB BENDER
-DIE INSTALL-
813-986-9000
PAGE 10
PRO-TOOLS
QUICK RELEASE NOTES
THE TENSION BOLT SERVERS TWO PURPOSES:
1) IN MOST CASES IT IS NECESSARY TO KEEP TENSION ON THE BOLT TO
PREVENT THE RELEASE FROM OPENING UP AND PREMATURELY
RELEASING THE TUBE.
2) WHEN APPLYING TENSION ON THE BOLT YOU DO NOT WANT TO OVER-
TIGHTEN THE BOLT. ONLY APPLY ENOUGH PRESSURE TO KEEP THE
RELEASE SEATED AND TO PREVENT ANY SPRINGBACK.
(KEEP THREADS WELL LUBRICATED AS THREAD DAMAGE IS NOT COVERED
UNDER OUR WARRANTY!)
IMPORTANT! BEFORE YOU RELEASE THE CYLINDER AFTER THE LAST STROKE.
BACK OFF THE TENSION BOLT SO THE QUICK RELEASE CAN
FUNCTION.