Pro-Ject Audio Systems Remote Box S - Manual (Page 10)

10
Programming of
remote commands
If you selected command windows for
devices not made by Pro-Ject, you have
to program the desired commands by
yourself. The example shows a television
control (left picture).
To program IR commands, tap on the
padlock in the upper right to open
it. Then tap on the control item you
want to program, e.g. “menu”. now
an insert (right picture) asks you to
press the respective key on the original
remote controller. Aim the controller at
the Remote Box S during this. As soon
as the command is recognized by the
Remote Box S, the insert disappears and
the desired command is successfully
programmed to the selected control item.
You can abort the programming at any
time by tapping on a place outside of the
insert.
Proceed with all desired command items
in the same way until all IR commands
are programmed. Finally, tap on the
padlock symbol again (left picture) to
lock the programming mode and prevent
unwanted changes. You can open the
padlock again at any time to change or
add commands.
Repeat this procedure in the same way
for all desired command windows. You
can change between the windows with a
simple wipe to the left or right.
With an upward wipe out of the black
bar at the bottom you can bring up the
overview menu alternatively and change
to the desired command window directly.