Char-Broil Patio Caddie 06601295 - Manual (Page 7)

• Clean burner twice a month when in regular
use. Clean burner prior to use after storage.
Spiders and insects like to build nests in
burner tubes (especially during colder
months). These nests can cause flashback
(fire in burner tube).
CAUTION CAUTION
Typical spider web inside burner
Match-lighting holes
Match Lighting
s Do not lean over grill while lighting.
1. Open lid. Turn gas on at LP tank.
2. Place lit long-stem match into one of three
large match lighting holes around burner
tube from beneath grill.
3. Push in and turn control knob to HIGH.
Be sure burner lights and stays lit.
General Grill Cleaning
•
Clean porcelain grill lid and bottom with soap and water or
non-abrasive cleaner to remove dust and grease. Use
Cream of Tarter for stubborn stains. Do not use a grill
cleaner on outside of grill. Wipe with vinegar. Do not paint
inside of grill.
•
Replace ceramic briquets as frequently as necessary to
avoid grease buildup and flare-ups.
•
Porcelain grate: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution
or specially formulated cleaner. Use non-abrasive scouring
powder for stubborn stains.
Cleaning the Gas Train
1. Turn gas OFF at knob and LP tank.
2. Remove cooking grate and grease cup (A).
3. Remove acorn nuts and burner plate (B).
4. Disconnect ignitor wire from electrode. Wipe ceramic portion
of electrode with rubbing alcohol and cloth (C).
5. Examine upper and lower surfaces of burner tube closely (D).
If any cracks or holes are found, replace burner tube.
6. Using garden hose (preferably with nozzle), force water
through burner tube to clean.
7. Replace burner place and acorn nuts.
8. If grill is to be stored, coat tube burner lightly with cooking oil.
Wrap protective cover over each end to keep insects out.
9. Attach flat end of ignitor wire to electrode.
10. Add briquets to grill.
11. Replace cooking grate and grease cup.
12. Before cooking again on grill, follow Gas Flow Check.
13. Grill must be completely dry before cooking .
A
s VERY IMPORTANT:
When replacing burner tube, burner tube must pass through hole
in valve cover and engage valve attached to control leg.
Valve
Burner Tube
A
B
C
D
Repainting Your Grill
•
After extended use and exposure to weather, paint on grill
legs may deteriorate or become spotted. Although this
detracts from grill’s appearance, it will not impair its
performance.
• To refinish grill legs, use wire brush and lightly sand with fine
grit sandpaper. Sanding allows new paint to adhere more
easily. Refinish legs with heat resistant paint.
Storing Your Grill
• Clean cooking grate and discard old briquets.
•
Apply a light coating of vegetable oil to heat plate.
•
Store in dry location.
•
When LP tank is connected to grill. Store both outdoors in
wee ventilated space and ut of reach of children.
•
Cover grill if stored outdoors. Choose from a variety of grill
covers offered by the manufacturer.
•
Store grill indoors ONLY if LP tank is disconnected, removed
from grill and stored outdoors.
06601295 • 7