Cabletron Systems 3H02-04 - Manual (Page 22)

Chapter 3: Configuring
Page 3-2 FE Switch Module User Guide
3.1 CONNECTING THE LOCAL CONSOLE MANAGER
Connect the Local Console Manager to the ATX. For specific
instructions, see Chapter 2, Connecting to the Network of the ATX User
Guide.
Make sure the ATX is powered on and press a few times. When
the ATX> prompt is displayed, the Local Console Manager is ready to
use. The default password is
.
3.2 LOCAL CONSOLE MANAGER COMMANDS
To configure the switch modules, refer to the ATX User Guide for Local
Console Manager commands generic to all modules, Make sure you’re
familiar with Local Console Manager before configuring the module. For
specific instructions on displaying the port status, see Chapter 4.