Louisville Tin and Stove HEDV254A - Manual (Page 15)

HEVE-5
VENT ENCLOSURE KIT
INSTALLATION INSTRUCTIONS
This kit must be installed by a qualified installer or
service technician.
STEP 1) Position end of Part No. 41610 enclosure body to
heater trim kit where pipes exit trim kit, centering
pipes inside body and attach to wall. Wall anchors,
not provided, may be required. Collector box may
be behind HEVE-5 Kit.
STEP 2) Cut to fit enclosure panel 1” beyond end of vent
run. Insert Part No. 41620 End Cap and attach
using three #8 screws provided.
SPECIAL INSTRUCTIONS
STEP 3) If more than one HEVE-5 Kit is used, attach Part
No. 72604 Trim Kit where ends meet.
STEP 4) If making a 90º turn, measure 1” beyond outside
turn and cut off enclosure panel. Notch panel on
surface of direction turn is being made to allow
pipes to pass through into next HEVE-5 Kit.
Attach second panel to wall and attach Part No.
72604 Trim Kit where two bodies meet. Install
end cap Part No. 41620.
Page 15
HEEL-1
90º ELBOW KIT
Contains 1 only P/N 72613 90º Elbow 2”