I/o board, Removing the i/o board, Replacing the i/o board – Dell Inspiron 15 (N5010, Early 2010) User Manual
Page 26
Back to Contents Page
I/O Board
Dell™ Inspiron™ N5010/M5010 Service Manual
Removing the I/O Board
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Follow the instructions from
step 3
to
step 13
in
Removing the System Board
.
4.
Remove the middle cover (see
Removing the Middle Cover
).
5.
Remove the I/O board from the latch on the computer base.
6.
Lift the I/O board off the computer base.
Replacing the I/O Board
1.
Follow the instructions in
Before You Begin
.
2.
Align the connectors on the I/O board with the slots on the computer base and press the I/O board until it is seated fully.
3.
Replace the middle cover (see
Replacing the Middle Cover
).
4.
Follow the instructions from
step 6
to
step 17
in
Replacing the System Board
.
5.
Replace the battery (see
Replacing the Battery
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
I/O board
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.