Dell Dimension XPS T___ - Manual (Page 51)

Power Supply
The 200-Watt (W) power supply can operate from an AC power source of 115 volts AC (VAC) at 60 hertz (Hz) or 230 VAC at 50 Hz. The power
supply provides the DC operating voltages and currents listed in the following table.
Table 2. DC Voltage Ranges
DC Power Cables
DC Power Connector Pin Assignments
The power-supply output voltages can be measured at the back (wire side) of the DC power connectors without disconnecting them. Figures 1
through 4 show the wire side of the connectors.
Figure 1. DC Power Connector P1
NOTE: The power supply produces DC voltages only under its loaded condition. The DC power cable connectors must be connected to
their corresponding power input connectors on the system board or drives in order to measure these voltages.
Voltage Range
Maximum Output
Current
Notes
+3.3 VDC +3.14 to +3.47 VDC 14.00 A The combined load on the +3.3-VDC and +5-VDC outputs cannot exceed 140
W.
+5 VDC +4.90 to +5.25 VDC 22.00 A The combined load on the +3.3-VDC and +5-VDC outputs cannot exceed 140
W.
–5 VDC –4.50 to –5.50 VDC 0.300 A
+12 VDC +11.40 to +12.60 VDC 6.00 A The +12-VDC output can withstand surges of up to 11.0 A to support disk start-
up operations.
–12 VDC –10.80 to –13.20 VDC 0.300 A
+5 VSB +4.75 to +5.25 VDC 1.2 A The +5 volts standby (VSB) is sometimes called volts flea power (VFP).