Compaq DS20E - Manual (Page 16)

Linux Installation and Configuration Guide for AlphaServer 16
ECG513/0100
SuSE Version 6.1 Distribution
Pre-Installation
Creating The BOOT and RAMDISK Floppies
Before you can begin to install the Linux software on your AlphaServer, you will need to create a
BOOT floppy and RAMDISK. These floppies contain the information required to initiate the
installation of Linux. The process varies depending upon what software distribution you are
using.
Creating floppies using a MS/Windows system
To create the BOOT and RAMDISK floppies, you will need to make use of a PC, which has
Internet access. The instructions below detail the process:
1. Create a directory on the PC into which you will copy files for Linux, for example \Linux.
2. Insert the Linux CD-ROM into the PC.
3. Copy the file ftp://tsx-11.mit.edu/pub/linux/dos_utils/rawrite.exe to "\Linux\rawrite.exe" on
the PC. This utility is required to build the floppies.
4. Copy the file "aboot_dualncr-qlogic" from ftp://ftp.digital.com/pub/DEC/Linux-
Alpha/Images/ to the \Linux directory on the PC and rename the file to aboot.
5. Copy the file "\disks\install" from the CD-ROM to the \Linux directory on the PC.
6. Insert a blank, formatted floppy into the PC.
7. Run the following command from the DOS command shell:
C:\Linux> rawrite
Enter source file name: aboot
Enter destination drive: a
Label this floppy "AlphaServer Linux BOOT Floppy".
8. Run the following command from the DOS command shell:
C:\Linux> rawrite
Enter source file name: install
Enter destination drive: a
9. Label this floppy "AlphaServer Linux RAMDISK Floppy".
With those two floppies in hand, you are now prepared to begin the installation process on your
AlphaServer.
Creating floppies using an UNIX system
To create the BOOT and RAMDISK floppies, you will need to make use of a computer, which
has Internet access. The instructions below detail the process. Note that depending upon what
version of unix and vendor computer you are using to perform this process, some minor
variations in the process may be required. The exact commands shown here are for Digital UNIX,
and should be similar to most other popular UNIX systems.
1. Insert the Linux CD-ROM into the computer, and mount it:
$ mount /cdrom