Dell Latitude D600 - Manual (Page 81)

Enable the Pointing Device option in the system setup program. If the problem persists, contact Dell .
Bad command or file name — Ensure that you have spelled the command correctly, put spaces in the proper place, and used the correct
pathname.
Cache disabled due to failure — The primary cache internal to the microprocessor has failed. Contact Dell .
CD drive controller failure — The CD drive does not respond to commands from the computer. See " Drive Problems ."
Data error — The floppy or hard drive cannot read the data. See " Drive Problems ."
Decreasing available memory — One or more memory modules may be faulty or improperly seated. Reseat the memory modules and, if
necessary, replace them. See " Adding Memory ."
Disk C: failed initialization — The hard drive failed initialization. Run the Hard-Disk Drive tests as described in " Using the Dell Diagnostics ."
Floppy drive 0 seek failure — The system configuration information may not match the hardware configuration. Run the Diskette tests as
described in " Using the Dell Diagnostics ."
Diskette read failure — The floppy disk may be defective. If the drive access light turns on, try a different disk. See " Drive Problems ."
Diskette subsystem reset failed — The floppy drive controller may be faulty. Run the Diskette tests as described in " Using the Dell
Diagnostics ."
Diskette write-protected — Because the floppy disk is write-protected, the operation cannot be completed. Slide the write-protect notch.
Drive not ready — The operation requires a floppy disk in the drive or a hard drive in the bay before it can continue. Insert a floppy disk, or
push the floppy disk all the way into the drive until the eject button pops out. Or, install a hard drive in the hard drive bay.
Error reading PCMCIA card — The computer cannot identify the PC Card. Reinsert the card or try another PC Card.
Extended memory size has changed — The amount of memory recorded in NVRAM does not match the memory installed in the computer.
Restart the computer. If the error appears again, contact Dell .
Gate A20 failure — A memory module may be loose. Reinstall the memory modules and, if necessary, replace them.
General failure — The operating system is unable to carry out the command. The message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action.
Hard-disk drive configuration error — The computer cannot identify the drive type. Turn off the computer, remove the hard drive , and boot
the computer from a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. Run the Hard-
Disk Drive tests as described in "
Using the Dell Diagnostics ."
Hard-disk drive controller failure 0 — The hard drive does not respond to commands from the computer. Turn off the computer, remove the
hard drive , and boot the computer from a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the
computer. If the problem persists, try another drive. Run the Hard-Disk Drive tests as described in " Using the Dell Diagnostics ."
Hard-disk drive failure — The hard drive does not respond to commands from the computer. Turn off the computer, remove the hard drive ,
and boot the computer from a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. If
the problem persists, try another drive. Run the Hard-Disk Drive tests as described in "
Using the Dell Diagnostics ."
Hard-disk drive read failure — The hard drive may be defective. Turn off the computer, remove the hard drive , and boot the computer from
a bootable floppy disk or CD. Then turn off the computer, reinstall the hard drive, and restart the computer. If the problem persists, try
another drive. Run the Hard-Disk Drive tests as described in "
Using the Dell Diagnostics ."
Insert bootable media — The operating system is trying to boot to a nonbootable floppy disk or CD. Insert a bootable floppy disk or CD.