Dell PowerEdge M610x - Manual (Page 303)

Installing Enclosure Components 303
4 Install the four screws to secure the front module cage assembly.
5 Install the I/O modules. See "Installing an I/O Module" on page 298.
6 Install the iKVM module. See "Installing an iKVM Module" on page 296.
7 Install the CMC module. See "Installing a CMC Module" on page 295.
8 Install the fan modules. See "Installing a Fan Module" on page 292.
9 Install the power supply modules. See "Installing a Power Supply Module"
on page 291.
10 Install the blades. See "Installing a Blade" on page 158.
Enclosure Control Panel Assembly
Removing the Enclosure Control Panel
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Press the system power switch to turn off the system. See "System Control
Panel Features" on page 16.
2 Remove the blades. See "Removing a Blade" on page 155.
3 Remove the bezel. See "Removing the Enclosure Bezel" on page 298.
4 Remove the two screws securing the control panel to the enclosure. See
Figure 4-10.