Dell PowerVault MD3200 User Manual
Page 66

66
Appendix—Manual Configuration of iSCSI
• Perform mutual authentication—If mutual CHAP authentication is
configured, select this option.
NOTE:
IPSec is not supported.
8 Click OK.
If you require a discovery session failover, repeat step 5 and step 6 (in this
procedure) for all iSCSI ports on the storage array. Otherwise, single-host
port configuration is sufficient.
NOTE:
If the connection fails, ensure that all IP addresses are entered correctly.
Mistyped IP addresses result in connection problems.
If you are using Windows Server 2008 Core version:
1 Set the iSCSI initiator services to start automatically (if not already set):
sc \\
2 Start the iSCSI service (if necessary): sc start msiscsi.
3 If you are not using mutual CHAP authentication, go to step 5.
4 Enter the mutual CHAP secret you entered for the storage array:
iscsicli CHAPSecret
5 Remove the target portal that you configured on the storage array during
target discovery:
iscsicli RemoveTargetPortal
6 Add the target portal with CHAP defined:
iscsicli QAddTargetPortal
[CHAP_username]
[CHAP_password]
where, [CHAP_username] is the initiator name and [CHAP_password] is
the target CHAP secret.
If you require a discovery session failover, repeat step 5 for all iSCSI ports
on the storage array. Otherwise, single-host port configuration is sufficient.
If you are using Red Hat Enterprise Linux 5, Red Hat Enterprise Linux 6,
SUSE Linux Enterprise Server 10, or SUSE Linux Enterprise Server 11:
book.book Page 66 Thursday, July 18, 2013 5:56 PM