Dell PowerVault MD3200 - Manual (Page 57)

Appendix—Manual Configuration of iSCSI 57
Step 2: Configure the iSCSI Ports on the Storage
Array
By default, the iSCSI ports on the storage array are set to the following IPv4
settings:
Controller 0, Port 0: IP: 192.168.130.101 Subnet Mask:
255.255.255.0 Port: 3260
Controller 0, Port 1: IP: 192.168.131.101 Subnet Mask:
255.255.255.0 Port: 3260
Controller 0, Port 2: IP: 192.168.132.101 Subnet Mask:
255.255.255.0 Port: 3260
Controller 0, Port 3: IP: 192.168.133.101 Subnet Mask:
255.255.255.0 Port: 3260
Controller 1, Port 0: IP: 192.168.130.102 Subnet Mask:
255.255.255.0 Port: 3260
Controller 1, Port 1: IP: 192.168.131.102 Subnet Mask:
255.255.255.0 Port: 3260
Table B-2. Initial Setup Tasks Dialog Box
Task Purpose
Rename the storage array To provide a more meaningful name than the
software-assigned label, Unnamed.
Set a storage array password To restrict unauthorized access. MDSM may ask
for a password before changing the
configuration or performing a destructive
operation.
Set up alert notifications
Set up e-mail alerts
Set up SNMP alerts To notify individuals (by e-mail) and/or storage
enterprise management consoles, such as Dell
Management Console, (by SNMP) when a
storage array component degrades or fails, or an
adverse environmental condition occurs.
Configure a storage array To create virtual disks and map them to hosts.
book.book Page 57 Thursday, July 18, 2013 5:56 PM