Dell Dimension 4600C - Manual (Page 47)

The following table shows Drive Configuration option information.
The following table shows Memory Information option information.
The following table shows CPU Information option information.
The following table shows Integrated Devices (Legacy Select Options) option information.
The following table shows Power Management option information.
Asset Tag Displays asset tag information.
Diskette Drive A: Sets the status of a floppy drive. The default is 3.5 inch, 1.44 MB.
SATA Primary
Drive:
If no device is attached as SATA primary drive, then Off is displayed. If a device is attached, the type of drive is displayed. If is
pressed, device information is displayed and the drive type can be set as Auto (default) or Off.
IDE Primary Drive
0:
If no device is attached as primary drive 0, then Off is displayed. If a device is attached, the type of drive is displayed. If is
pressed, device information is displayed and the drive type can be set as Auto (default) or Off.
IDE Primary Drive
1:
If no device is attached as primary drive 1, then Off is displayed. If a device is attached, the type of drive is displayed. If is
pressed, device information is displayed and the drive type can be set as Auto or Off (default).
IDE Secondary
Drive 0:
If no device is attached as secondary drive 0, then Off is displayed. If a device is attached, the type of drive is displayed. If is
pressed, device information is displayed and the drive type can be set as Auto (default) or Off.
IDE Secondary
Drive 1:
If no device is attached as secondary drive 1, then Off is displayed. If a device is attached, the type of drive is displayed. If is
pressed, device information is displayed and the drive type can be set as Auto or Off (default).
IDE Drive UDMA: Turns IDE Drive UDMA on and off. The default is On.
Option Function
Installed System Memory Displays the amount of installed system memory.
System Memory Speed Displays the speed of your system memory.
System Memory Channel Mode Displays the mode of your system memory.
AGP Aperture Displays the amount of aperture memory. The default is 128 MB.
Option Function
Hyper-Threading Enables Hyper-Threading. The default is Disabled.
NOTE: This option is displayed only if the installed microprocessor supports Hyper-Threading.
CPU Speed Sets the CPU speed. The default is Normal.
Bus Speed Displays the bus speed.
Processor 0 ID Displays processor ID.
Clock Speed Displays clock speed.
Cache Size Displays cache size.
Option Function
Sound Turns the integrated sound off and on. The default is On.
Network Interface Controller Turns the network interface controller off and on or on with PXE support. The default is On.
Mouse Port Turns the mouse port off and on. The default is On.
USB Emulation Turns USB emulation off and on. The default is On.
USB Controller Turns the USB controller off and on. The default is On.
Parallel Port Displays parallel port settings when is pressed. The default mode is PS/2 and the I/O address default is 378h.
Primary Video Controller Sets the primary video controller. The default is Auto.
Onboard Video Buffer Sets the onboard video buffer size. The default is 1 MB.
Option Function
Suspend Mode Displays the suspend state used by the computer. The default is S3.
AC Power Recovery Enables AC power recovery to occur. The default is Off.