Dell Dimension 4600C - Manual (Page 24)

Installing an AGP Card
1. To add or replace the card, slide the card clip toward the front of the computer to ensure that the clip is unlocked.
2. Gently press the card into the AGP connector until it is fully seated.
3. Slide the card clip toward the back of the computer, ensuring that the tab fits into the notch on the front end of the card.
4. Secure the card by lowering the hinged lever on the back panel.
5. Close the computer cover .
6. Attach the computer stand (optional).
7. Connect the monitor cable to the card's video connector.
8. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
NOTE: If you purchased the optional video card, ensure that you connected your monitor cable to the correct video connector.
NOTICE: You must use low-profile cards for your computer. A full-size card can damage the computer or the card.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.