Dell Inspiron 23 (2350, Mid 2013) - Manual (Page 62)

Replacing the System Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You
must enter the Service Tag in the BIOS setup program after you replace
the system board.
NOTE: Replacing the system board removes any changes you have
made to the BIOS using the BIOS setup program. You must make the
desired changes again after you replace the system board.
Procedure
1 Align the screw holes on the system board with the screw holes on the
computer base.
2 Replace the screws that secure the system board to the computer base.
3 Connect the USB-board cable to the system board.
4 Adhere the USB-board cable to the USB board.
5 Connect the fan cable to the system board.
Post-requisites
1 Replace the processor .
2 Replace the heat sink .
3 Replace the coin-cell battery .
4 Replace the wireless card .
5 Replace the mSATA card .
6 Follow the procedure from step 5 to step 8 in “Replacing the Hard Drive ”.
7 Replace the memory module(s) .
8 Replace the computer base .
9 Replace the base cover .
62