Dell PowerEdge 6850 - Manual (Page 25)

SCSI Hard-Drive Indicator Codes
If RAID is activated, two indicators on each of the hard-drive carriers provide information on the status of the SCSI hard drives. RAID can be enabled either by
using ROMB on the system board or by using a RAID card connected to the system board. See
Figure 2 -3 and Table 2 -3 . The SCSI backplane firmware controls
the drive power-on/fault indicator.
Figure 2-3. SCSI Hard-Drive Indicators
Table 2 -3 lists the drive indicator patterns. Different patterns are displayed as drive events occur in the system. For example, if a hard drive fails, the "drive
failed" pattern appears. After the drive is selected for removal, the "drive being prepared for removal" pattern appears, followed by the "drive ready for
insertion or removal" pattern. After the replacement drive is installed, the "drive being prepared for operation" pattern appears, followed by the "drive online"
pattern.
Table 2-3. Hard-Drive Indicator Patterns
NOTE: If a RAID controller is not present, the green power-on/fault indicator is on if power is available to the drive. The drive-activity indicator also blinks
when the drive is being accessed.
Condition Indicator Pattern
Identify drive The green power-on/fault indicator blinks four times per second.
Drive being prepared for removal The green power-on/fault indicator blinks two times per second.
Drive ready for insertion or removal Both drive indicators are off.
Drive being prepared for operation The green power-on/fault indicator is on.
Drive predicted failure The power-on/fault indicator slowly blinks green, amber, and off.
Drive failed The amber power-on/fault indicator blinks four times per second.
Drive rebuilding The green power-on/fault indicator blinks slowly.
Drive online The green power-on/fault indicator is on.