Dell S300wi Projector - Manual (Page 39)

Using Your Projector 39
NOTE: OSD warning messages - low battery
• The Low Battery warning message pops up when the battery voltage is
lower than 2V. At this condition, the pen can still work about 1~2 hours.
• The pen will be disabled when the battery voltage is lower than 1.8V.
NOTE: OSD warning messages - out of range
The situations below may cause the pen sensor out of range:
• The pen doesn't point toward the screen.
• The pen is too far away from the screen.
• The projector brightness is too low for detection.
NOTE: Combinations of buttons
• Left + Function: The Pen Information menu appears on the screen.
• Right + Function: The Set Function menu appears on the screen. Use
Left/Right to move up/down and use Function to enter/apply.
• When Toggle is selected in the Set Function menu, press the Function
button to select Normal/Draw/Stable mode.
NOTE: Interactive pen cannot support Windows Mouse property function
"Switch primary and secondary buttons".
2 Left This button acts like the left click button of a
mouse.
3 Function Functions available are listed in OSD Menu "Set
function" (see page 64).
NOTE: Double click Function button will
act as Undo, if supported by the software.
4 LED indicators Two LED indicators are available: Green and
Amber (see on "Interactive Pen LED Guiding
Signals" on page 110).
5 Right This button acts like the right click button of a
mouse.
6 Reset Press to reset the interactive pen configuration.