Status light board, Removing the status light board – Dell Alienware M17x R3 (Early 2011) User Manual
Page 75

Status Light Board
75
18
Status Light Board
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery Pack" on page 13) before working inside the computer.
Removing the Status Light Board
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery pack (see "Removing the Battery Pack" on page 13).
3 Remove the compartment door (see "Removing the Compartment Door"
4 Remove the center control cover (see "Removing the Center Control
5 Remove the keyboard (see "Removing the Keyboard" on page 55).
6 Remove the display assembly (see "Removing the Display Assembly" on
7 Disconnect the status light board cable from the connector on the system
board.
8 Note the routing of status light board cable and remove the cable from the
routing guides.
9 Remove the two screws that secure the status light board to the palm rest
assembly.