Camera module, Removing the camera module, Replacing the camera module – Dell Inspiron Mini 10 (1012, Late 2009) User Manual
Page 8
Back to Contents Page
Camera Module
Dell™ Inspiron™ 1012 Service Manual
Removing the Camera Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the hard-drive assembly (see
Removing the Hard-Drive Assembly
).
5.
Remove the palm rest assembly (see
Removing the Palm Rest Assembly
).
6.
Remove the hinge cover (see
Removing the Hinge Cover
).
7.
Remove the display assembly (see
Removing the Display Assembly
).
8.
Remove the display bezel (see
Removing the Display Bezel
).
9.
Disconnect the camera cable from the connector on the camera module.
10.
Gently remove the camera module stuck to the display cover.
Replacing the Camera Module
1.
Follow the procedures in
Before You Begin
.
2.
Use the alignment posts to place the camera module on the display cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
camera module
2
camera cable connector