Display bezel, Removing the display bezel – Dell Inspiron Mini 10 (1012, Late 2009) User Manual
Page 17
1.
Follow the procedures in
Before You Begin
.
2.
Place the display assembly in position and replace the screw that secures the display assembly to the computer base.
3.
Replace the display cable grounding screw.
4.
Route the Mini-Card antenna cables through the routing guides on the computer base.
5.
Connect the display cable to the connector on the system board.
6.
Connect the antenna cables to the Mini-Card (see
Replacing the Mini-Card(s)
).
7.
Replace the screw that secures the display assembly to the computer base.
8.
Replace the hinge cover (see
Replacing the Hinge Cover
).
9.
Replace the palm rest assembly (see
Replacing the Palm Rest Assembly
).
10.
Replace the hard-drive assembly (see
Replacing the Hard-Drive Assembly
).
11.
Replace the keyboard (see
Replacing the Keyboard
).
12.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the procedures in
Before You Begin
.
2.
Remove the display assembly (see
).
3.
Remove the two rubber pads that cover the screws that secure the display bezel to the display cover.
4.
Remove the two screws that secure the display bezel to the display assembly.
5.
Using your fingertips, carefully pry up the inside edge of the display bezel.
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1
screws (2)
2
rubber pads (2)
3
display bezel