Dell AXIM X3 - Manual (Page 105)

G e t t i n g C o n n e c t e d 105
8 Install the network card driver, if required.
See the documentation that came with your network card.
9 Insert the network card into your device.
•
If a network with a broadcast SSID is detected, the wireless
network icon, , and the New Network Detected bubble
appear in the navigation bar. Go to step 10.
• If a network with a broadcast SSID is not detected, skip to step 11.
10 Tap The Internet.
NOTE:
If multiple networks are detected, tap the network to which you want to
connect, tap The Internet, and tap Connect.
11 Tap the Start button → Settings → Connections tab → Connections.
12 Tap the Wireless Ethernet icon.
13 On the Wireless tab, tap New Settings.
14 Enter the SSID next to Network Name, and tap The Internet.
15 Tap the Authentication tab to enable or disable WEP settings,
depending on your network type.
16 Tap OK.
17 Tap the connection icon, , that appears in the navigation bar.
18 Tap the name of your VPN connection to enable it.
Ending a Connection
To disconnect:
• When connected through dial-up or VPN, tap the Connection icon on
your navigation bar and tap End.
• When connected through a cable or cradle, detach your device from
the cable or cradle.
• When connected through the infrared sensor, move the device away
from the computer.
• When connected through a network (Ethernet) card, remove the card
from your device.