Dell Latitude D631 (Early 2009) - Manual (Page 15)

7. Squeeze the flex cable release levers at either side of the top flex cable connector, releasing the connector.
Removing the Display Hinges
1. Follow the instructions in Before You Begin .
2. Remove the display assembly (see Display Assembly ).
3. Remove the display bezel (see Removing the Display Bezel ).
4. Remove the display panel (see Removing the Display Panel ).
5. Remove the M2.5 x 5-mm screw from the right display hinge.
6. Lift the right display hinge off the two alignment pins and out of the display back cover.
7. Repeat step 5 and step 6 for the left display hinge.
Back to Contents Page
1 top flex cable
connector
2 flex cable release levers
(2)
3 back of display panel
4 inverter board 5 bottom flex cable
connector
6 pull tab on bottom flex cable
connector
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1 M2.5 x 5-mm screw 2 display hinges (2)
(left and right) 3 display back cover
4 alignment pin