Removing the display panel – Dell Latitude D631 (Early 2009) User Manual
Page 13
4.
Remove the six M2.5 x 5-mm shoulder screws from the front of the bezel.
5.
Starting from the inside edges of the bezel, use your fingers to pry the bezel upward and outward from the display panel. Release the sides of the bezel
next; if necessary, use a plastic scribe to release the corners of the bezel from the display panel.
Removing the Display Panel
1.
Follow the instructions in
Before You Begin
.
2.
Remove the display assembly (see
3.
).
4.
Remove the three M2 x 3-mm screws from each side of the display panel.
1 screw covers/display bumpers (6) 2 M2.5 x 5-mm shoulder screws (6) 3 display bezel
4 display panel
5 display back cover
NOTICE:
Carefully separate the bezel from the display back cover to avoid damage to the bezel.
NOTICE:
To avoid damaging the computer when replacing the display bezel, ensure that the bezel edges line up with those on the display back cover,
and snap into place around the entire perimeter of the display back cover.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as a connector on the back of the computer.
1
display panel
2
M2 x 3-mm screws (6)
3
display back cover
4
LED ribbon cable
5
bracket tabs (4)