Dell 1700/n Mono Laser Printer - Manual (Page 32)

3 2 S e t t i n g U p f o r L o c a l Pr i n t i n g
w
w
w
.
d
e
ll.
co
m/
su
p
p
l
i
e
s |
su
p
p
o
r
t
.
d
e
l
l.c
o
m
Using Windows 2000 With a USB or Parallel Cable
When you attached the cable and turned on the printer, the Found New Hardware Wizard
appeared on your computer screen.
1 Insert the Drivers and Utilities CD, and then click Next.
2 Select Search for a suitable driver, and then click Next.
3 Select Specify a location only, and then click Next.
4 Browse to the location of the printer driver on the Drivers and Utilities CD.
D:\Drivers\Print\Win_2kXP\
Replace D:\ with the letter of your CD-ROM drive (for example, type D:\ where D is
the drive letter of your CD).
5 Click Open, and then click OK.
6 Click Next to install the driver that is displayed.
D:\Drivers\Print\Win_2kXP\dkaap2da.inf
7 Click Finish when the software is installed.
8 The Drivers and Utilities CD should launch the installation software automatically.
If the CD does not automatically launch, click Start
→
Run, type D:\setup.exe
(where D is the drive letter of your CD), and then click OK.
9 When the Drivers and Utilities CD screen appears, click Personal Installation - Install
the printer for use on this computer only to install the additional software for your
printer.
10 Select your printer from the drop-down box.
11 Select Typical Installation (recommended), and then click Install.
When all of the files are installed on your computer, the Congratulations screen
appears.
12 Click Print a Test Page to verify printer setup.
13 Click Finish to exit when the test page prints successfully.