Char-Broil 463222209 - Manual (Page 8)

8
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Turn controls and gas source or tank OFF when not
in use.
WARNING
minutes, then repeat lighting procedure.
Sideburner Match Lighting
3.Place lit match near burner.
4.Turn sideburner knob to the HI
1.Turn all burner control valves to the OFF position.
4.Push in and turn far right or far left knob to HI position. Be
Main Burner Match-Lighting
 Do not lean over grill while lighting.
2.Open lid during lighting. Turn ON gas at LP cylinder.
3.Place match into match holder (hanging from side of cart.)
Light match, place into lighting hole on top between emitter
plate mounting brackets.
sure burner lights and stays lit. Verify burner flame through
6. Ignite remaining burners by repeating steps 3 through 5 for
each burner.
1. Turn all burner control valves
to the OFF position.
2. Open the sideburner lid.
Turn ON gas at LP cylinder.
position, Be sure burner lights and stays lit.
WARNING: Top cover must be open when sideburner(s)
is in operation.
Burner Flame Check
•Remove cooking grates and troughs. Light burners, rotate
knobs from the HI position to the LOW position. You should
HI position. Perform burner flame check
on sideburner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the Troubleshooting Section.
Turning Grill Off
•Turn all knobs to the OFF position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
•Turn gas OFF at LP cylinder. Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between each collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is OFF at LP cylinder before
checking valves. Knobs lock in position. To check
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
OFF
OFF
Sideburner Ignitor Lighting
 Do not lean over grill while lighting.
1. Turn all burner control valves to the OFF position
3. Turn SIDEBURNER knob to the HI position, push and hold
4. Once burner has ignited, turn knob to desired setting.
5. If sideburner does not light, turn knob to the OFF position, wait 5
2. Open the sideburner lid. Turn ON gas at LP cylinder.
the ELECTRONIC IGNITOR button.
Emitter Plate Brackets
burner ports.
5.If ignition does NOT occur in 5 seconds, turn the burner
control knob to OFF position, wait 5 minutes, and repeat the match
lighting procedure
see a smaller flame in the LOW position than seen on the
LOW position
HI position