Dell PowerVault MD1220 - Manual (Page 42)

42
Installing Enclosure Components
Control Panel
Removing the Control Panel
1 Turn off the enclosure and host server.
2 Disconnect all the power cables connected to the enclosure.
3 Remove the hard drives from:
– slots 0 to 2 in PowerVault MD1200
– slots 0 to 5 in PowerVault MD1220
See "Removing a Hard Drive" on page 31.
NOTE:
Mark each hard drive with it’s slot position as you remove it.
4 Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the enclosure in
PowerVault MD1200. See Figure 3-11.
– Pulling the release pin toward the front of the enclosure in PowerVault
MD1220. See Figure 3-12.
book.book Page 42 Monday, December 7, 2009 4:51 PM