Computer orientation – Dell Latitude D510 User Manual
Page 3
1.
Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
2.
3.
If the computer is connected to a docking device, undock it. See the documentation that came with your docking device for instructions.
4.
Disconnect any telephone, network, and USB cables from the computer.
5.
Disconnect your computer power supply and all attached devices from their electrical outlets.
6.
Remove any installed PC Cards from the PC Card slot.
7.
Close the display and turn the computer upside down on a flat work surface.
8.
Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the battery bay
9.
Remove any installed
memory modules
,
modems
,
Mini PCI cards
,
internal cards with Bluetooth wireless technology
,
backup batteries
, and
optical
devices
.
10.
Remove the
hard drive
.
Computer Orientation
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network port or device.
NOTICE:
To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's
electronic components. You can do so by touching an unpainted metal surface.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you service the computer.