Dell Vostro 230 (Early 2010) - Manual (Page 4)

l DVMT Mode (default)
l UMA Mode
DVMT/FIXED Memory — Allows you to set the size of the DVMT/FIXED Memory. Available Settings are:
l 128 MB
l 256 MB (default)
l Maximum DVMT
Integrated
Peripherals
Configuration ATA/IDE Configuration —
l Disabled
l Compatible
l PEG/PCI (default)
USB Functions —
l Enabled (default)
l Disabled
USB Storage Functions —
l Enabled (default)
l Disabled
Audio Controller —
l Enabled (default)
l Disabled
Integrated NIC —
l Enabled (default)
l Disabled
LAN Boot ROM —
l Enabled (default)
l Disabled
Serial Port Address —
l 3F8/IRQ4 (default)
l 2F8/IRQ3
l 3E8/IRQ4
l 2E8/IRQ3
Bootup Num-Lock —
l On (default)
l Off
Quick Boot —
l Enabled (default)
l Disabled
Power
Low Power
Mode Enables or disables low power mode.
This option is disabled by default.
When low power mode is enabled, the integrated network card is disabled when the computer shuts down or hibernates. Only add-in
network cards will be able to remotely wake the computer.
Suspend mode Sets the energy-saving mode of the ACPI function. It determines the Standby mode in the operating system. Available settings are:
l S1 (POS)
l S3 (STR) (default)
When you select S1 (POS) mode, the power does not shut off and the supply status remains as it is. But when you select S3 (STR) mode, the
power is cut off after a delay. The computer’s status before it enters STR is saved in memory, and the computer can quickly return to that
previous status when the STR function wakes.
USB Wakeup
From S3 Allows the system to wake up from USB peripheral that supports wake from USB. Available settings are:
l Enabled (default)
l Disabled
Restore on AC
Power Loss Determines what action the computer will take when power is restored. Available settings are:
l Last State
l On
l Off (default)
Resume by PS2 Allows the computer to resume back after go to standby using PS2 Devices. Available settings are: