Dell Vostro 230 (Early 2010) - Manual (Page 18)

Back to Contents Page
Power Button and Hard Drive Light Assembly
Dell™ Vostro™ 230 Service Manual— Mini Tower
Removing the Power Button and Hard Drive Light Assembly
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the cover .
3. Remove the front bezel .
4. Disconnect the power button and hard drive light cables from the system board.
5. Unthread and pull the power button and hard drive cables out towards the front of the computer.
6. Press the tabs holding the power button and hard drive light in place to loosen them from the chassis.
7. Unthread the cables from their clips on the front of the chassis, and remove the power button and hard drive light assembly from the computer.
Replacing the Power Button and Hard Drive Light Assembly
To replace the power button and hard drive light assembly, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.