Dell Dimension 3100C User Manual
Page 96
96
Appendix
www
.dell.com | support.dell.com
Changing Boot Sequence for the Current Boot
You can use this feature, for example, to restart your computer to a USB device such as a floppy
drive, memory key, or CD-RW drive.
NOTE:
If you are booting to a USB floppy drive, you must first set
Diskette Drive to OFF in system setup
1 If you are booting to a USB device, connect the USB device to a USB connector (see page 88).
2 Turn on (or restart) your computer.
3 When
F2 = Setup, F12 = Boot Menu
appears in the upper-right corner of the screen,
press
If you wait too long and the operating system logo appears, continue to wait until you see the
Microsoft Windows desktop. Then shut down your computer (see page 53) and try again.
The Boot Device Menu appears, listing all available boot devices. Each device has a number
next to it.
4 At the bottom of the menu, enter the number of the device that is to be used for the current
boot only.
For example, if you are booting to a USB memory key, highlight USB Flash Device and press
NOTE:
To boot to a USB device, the device must be bootable. To ensure that a device is bootable, check
the device documentation.
Changing Boot Sequence for Future Boots
1 Enter system setup (see page 91).
2 Use the arrow keys to highlight the Boot Sequence menu option and press
the menu.
NOTE:
Write down your current boot sequence in case you want to restore it.
3 Press the up- and down-arrow keys to move through the list of devices.
4 Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5 Press plus (+) or minus (–) to move a selected device up or down the list.